CVE-2026-79980

The DHCPv4 client in subsys/net/lib/dhcpv4/dhcpv4.c maintained its transaction identifier (iface->config.dhcpv4.xid) as a counter rather than as a per-transaction random value. It was seeded once with sys rand32 get() in dhcpv4 start internal(), incremented by one in dhcpv4 send discover() and dhcpv4 send decline(), and never changed by dhcpv4 send request() — so every RENEWING and REBINDING exchange reused, unchanged, the identifier that had already appeared on the wire in the broadcast DHCPDISCOVER at boot, and where the identifier did move it moved predictably by one. RFC 2131 4.1 requires a single identifier per transaction, chosen so that clients are unlikely to collide.

This identifier is the client's only unpredictable reply-validation token. net dhcpv4 input() accepts a BOOTP reply on op, a matching xid, and a matching chaddr (the interface MAC, which is public); the UDP callback is registered with a wildcard remote address and port, and no server-identifier or source-address check is applied. An attacker who learns one identifier — for example any host on the same segment that sees the broadcast DHCPDISCOVER, or a DHCP server or relay on a network the device previously joined — therefore retains a valid token for the device's whole uptime, and can predict the identifiers of later exchanges, without having to observe the unicast renew traffic or race the legitimate server.

A forged reply that passes those checks has effect regardless of client state, because dhcpv4 parse options() applies its side effects before the state machine gate in dhcpv4 handle reply(): the router option calls net if ipv4 set gw() and the DNS option calls dns resolve reconfigure(). A single accepted datagram can thus repoint the device's default gateway and resolvers at attacker-controlled addresses, redirecting its traffic; during RENEWING or REBINDING a forged DHCPACK re-binds the lease with attacker-chosen parameters and a forged DHCPNAK removes the address and restarts configuration.

The fix draws a fresh sys rand32 get() value at each point where a transaction begins — entering SELECTING, RENEWING and REBINDING, and at the INIT/INIT-REBOOT entry taken when an interface with a lease goes down — while REQUESTING and DECLINE keep the identifier of the exchange they belong to, as RFC 2131 requires. As a side effect the client also no longer discards a slow server's offer after retransmitting a discover, and the initial-discover backoff now draws its own randomness instead of deriving it from the identifier.