PT-2026-152494
CVE-2026-99614
·
Published
2026-11-20
·
Updated
2026-11-20
Description by
Score
N/A
Not availableNo severity ratings or metrics are available. When they are, we'll update the corresponding info on the page.
In the Linux kernel, the following vulnerability has been resolved:
drm/nouveau/nvkm: clear use.enabled when subdev init fails
On Kepler boards without the video decode falcon firmware installed
(msvld/mspdec/msppp), every other VA-API decode attempt binds to an
engine with no ucode loaded. The submitted work never completes, which
leads to a context switch timeout, a channel recovery that cannot reset
the engine, and eviction waits on fences that never signal. The process
ends up stuck in D state, or killed by SIGBUS when it touches a buffer
evicted after the wait times out:
msvld: unable to load firmware data
msvld: init failed, -19
fifo: SCHED ERROR 0a [CTXSW TIMEOUT]
vo[5444]: channel 14 killed!
WARNING: drivers/gpu/drm/nouveau/nvkm/engine/fifo/runl.c:117 at nvkm runl rc+0x2a4/0x3b0 [nouveau]
[TTM] Buffer eviction failed
WARNING: drivers/gpu/drm/nouveau/nouveau bo.c:1092 at nouveau bo move ntfy.part.0+0x9b/0x100 [nouveau]
Tracing nvkm subdev ref() and nvkm subdev init () shows the pattern:
a reference taken with enabled=0 runs nvkm falcon init(), which
returns -ENODEV; the next reference sees enabled=1 and succeeds
without running it.
Clear use.enabled when init() fails, so that every later reference
retries init and fails cleanly. The other readers of use.enabled are
fini() handlers that use it to skip teardown, which they now also do
after a failed init().
On a GK107 (Quadro K1100M) without video firmware, playing H.264 with
mpv --hwdec=auto: without this patch the GPU channel is killed within a
minute and mpv hangs; with it, VA-API decoder creation fails, mpv falls
back to software decoding, and no faults are logged.
Found an issue in the description? Have something to add? Feel free to write us 👾